17/3/2011
Now that the transmission was fully dismantled i began inspecting parts such as bearings, gears, syncro-hubs for any wear/damage looking for cracks, chips and scoring, calculating gear ratios by counting the teeth on each gear and then using the formula driven/driver=ratio and checking input/output shafts for their diameter using a micrometer. I recorded my findings in the work book. After that was done i began re-assembling the transmission following the manual.
Hi stephen ,as you can see i am following so for me this is pleasing.So far i have looked at transmissions and some good work has been done at the start but has dropped off towards the end .You could add a lot more detail into your Blog with the tasks during the practical lessons, like gear ratios measuring input and output shafts.I have yet to view all your other work .
ReplyDelete